PHC10-3 Plus Probe Head Control – RS232

$3,255.00

The PHC10-2 controls any one of the PH10T, PH10M or PH10MQ heads based on commands received from either the CMM controller or the HCU1 (if fitted).   A-1368-0100

The PHC10-2 controls any one of the PH10T, PH10M or PH10MQ heads based on commands received from either the CMM controller or the HCU1 (if fitted). In addition to this, the PHC10-2 interrogates the head and reports back:

  • the heads A and B positions,
  • any problems found

The PHC10-2 does not process any of the probe sensor signals. These are railed clean
through through the heads axes and controller to the probe interface.

Data transmission RS232 or IEEE

User definable parameters

  • Seria:l Baud rate 300 – 19200 parallel address, parallel poll bit
  • Current Consumption: (at 240V) less than 500mA
  • Voltage range: 85-264V 47/66Hz automatic selection
  • Input connectors: 15 way ‘D’
  • Probe output connectors: 7 pin DIN or 9 way ‘D’ type
  • Mounting: rack mounted or stand alone
  • Hand control unit: HCU1 only

Weight (g) 2860
Length (mm) 220
Height (mm) 88
Width (mm) 289.3